Remove both earbuds from the charging case and place them near each other. So, I did per as the instruction manual but that didn’t really work at first. The speaker’s charging cables are loose, charging port is broken, or the battery is broken. If the red light on the side of the device is not turning on even when plugged in, then you have a faulty charging port. It may take around 3-4 weeks. Put both earbuds into the case…wait a few seconds then proceed to step 3 Take out the right earbud and tap the side 4 times, then out back into the case. If there are many Bluetooth devices all being used at once it can cloud the connection between your device and the speaker. To avoid this turn off Bluetooth devices that are not being used and test your sound quality again. Put the other earbud in the charging case and repeat Step 3. Remove any obstacles between the speaker and your device, and move your device as close as you can to your ANKER SoundCore and try to pair again. If the red light on the side of the device is turning on, but the device has little to no battery life, you have a faulty battery. Charging Charge the charging case before using the earbuds for the first time. Anker Soundcore Liberty 2 Wireless Earbuds, Diamond-Inspired Drivers, 32H Playtime, HearID Personalized Sound, Bluetooth 5.0, Bluetooth Headphones, 4 Mics with Uplink Noise Cancellation 4.3 out of 5 stars 1,679. Take both out of the case at the same time, you will see the lights on top flashing white or blinkin in a breathing way. Step 5. 1. When you remove them from the case for the first time they automatically enter pairing mode, which takes some of the guesswork out of the initial setup process. Leave it for a bit (it’ll blink white a lot). What can I do to stop it bleeping and then on third bleep shuts down speaker ??? Upgraded, Anker Soundcore Liberty Neo True Wireless Earbuds, Pumping Bass, IPX7 Waterproof, Secure Fit, Bluetooth 5 Headphones, Stereo Calls, Noise Isolation, One Step Pairing, Sports, Work Out(Gray) Visit the Soundcore Store. Do not separate the two devices for more than 3 feet while pairing. Try pressing and holding all buttons on the SoundCore simultaneously, for about 30 seconds, then press and hold the power button until it turns on. Reply. The Anker Soundcore Spirit Dot 2 earbuds are surprisingly easy to use. The speaker’s power button does not function properly. An awesome team of students from our education program made this wiki. After your phone has connected to Liberty Air, delete it from the list of paired devices. 4. If your device is out of range of your speaker, they will not be able to maintain a Bluetooth connection. Pair your device with Liberty Air 2. Ensure all charging cables work properly. I then put the left earbud in the charging case and close the lid and took them out both and let them connect to each other by placing them literally like in 69 shape until the right one started blinking and left one slowly blinking. You can send firstname.lastname@example.org a message and see if they can help you. The speaker is out of range, or has faulty Bluetooth. You can replace this using this guide. Turn on the Bluetooth on your device and find “Soundcore Liberty Air” to pair them. You may refer to the attachment to find the serial number. iPhone is 5” away from speaker. Weighing in at just 9.3 ounces, the SoundCore Life Q20 features an adjustable padded headband with foldable earcups that swivel up to 90 degrees, handy for stashing the headset into a backpack or a purse. Click on the Custom Command button in the lower right corner to enter the Custom Command page. But mine doesn’t show any lights at all. One-Step Pairing: Life Note wireless earphones use our PUSH AND GO technology to automatically connect with the last paired device. 1. Place the earbuds in the charging case before you start charging.